Use cap screws, the suitable length is the length of the plug (L) + the thickness of the base of the stand + 5 mm. Plug installation: Tap the plugs into the drill holes with a hammer and align the mounting holes on the stand. Basic rule for drilling depth: plug length or concrete screw length (L) + 5 mm. Drill a hole in the concrete using a good quality concrete drill bit and the impact function of the impact drill. Use a roll gauge and a vatupass to make sure the TV comes straight. Installation of NAT 8 L and NAT 10 L nylon plugs:ĭetermine the correct position of the stand and mark the locations of the mounting holes with a pen on the mounting base. 8 mmĬoncrete screw S-CSA can also be used for mounting the stand with plaster thicknesses of 0-25 mm If the diameter of the mounting holes in the base of the wall bracket is min. Use a NAT 10 L nylon plug and a 6.0-8.0 mm diameter cap screw. The total thickness of the base of the stand and the plaster is 30 mm or less Use a NAT 8 L nylon plug and a 4.5 to 6.0 mm diameter cap screw. The total thickness of the base of the stand and the plaster is 5 mm or less Sometimes, in order to determine the thickness of the plaster layer, it is necessary to make a test drill in an invisible place, such as behind a baseboard.īased on the thickness of the plaster layer, either NAT 8 L or NAT 10 L nylon plugs with a long neck or the S-CS SS 8×75 concrete screw are chosen as the fastener. In plastered walls, the anchoring of the wall mount of the flat screen TV must be attached to the load-bearing structure using plugs with a long neck or an 8 mm flanged concrete screw. In older houses, the load-bearing wall structures are often constructed of concrete or fired solid brick, in addition to which the wall may have been covered with thick plaster.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |